2005-2008 Yaris · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Nov 2006


1. REMOVE REAR COMBINATION LIGHT SERVICE COVER LH

E113817E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the rear combination light service cover.


2. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH

E108436
  1. Remove the 2 nuts.

  1. Disconnect the connector.

  1. E127255E01
    Slide the tail light (rear combination light) toward the rear of the vehicle.


3. REMOVE REAR COMBINATION LIGHT BODY GASKET LH

E127256
  1. Remove the rear combination light body gasket.

    NOTICE:
    1. Detach the gasket if it adheres to the body.
    2. Do not reuse a removed gasket. Replace it with a new one to prevent water from entering.


4. REMOVE REAR COMBINATION LIGHT BULB

  1. E109082
    Turn the rear combination light socket and wire, in the direction indicated by the arrow in the illustration, to remove it.

  1. Remove the rear combination light bulb (turn signal light) from the socket and wire.

  1. E111050
    Turn the rear combination light socket and wire, in the direction indicated by the arrow in the illustration, to remove it.

  1. Remove the rear combination light bulb (back up light) from the socket and wire.


5. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH
  1. Disconnect the connector and remove the rear combination light socket and wire.

← COMPONENTS (from Nov 2006)INSTALLATION (from Nov 2006) →