2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2006


1. INSTALL FRONT EXHAUST PIPE ASSEMBLY

  1. A104634
    Using vernier calipers, measure the free length of the compression spring.

    Minimum length (Front side):
    40.5 mm (1.594 in.)

    Minimum length (Rear side):
    38.5 mm (1.516 in.)

    If the length is not as specified, replace the compression spring.

  1. A104635E01
    Using a plastic hammer and a wooden block, tap in a new exhaust pipe gasket until its surface is flush with the exhaust manifold.

    NOTICE:
    1. Install the exhaust pipe gasket in the correct direction.
    1. Do not damage the outer surface of the exhaust pipe gasket.
    1. Do not reuse the exhaust pipe gasket.
    1. Do not push in the gasket with the exhaust pipe when connecting it.

  1. A159351
    Install the 3 exhaust pipe supports.

  1. A159381
    Install the front exhaust pipe assembly with the 2 compression springs and 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }

  1. A137397E01
    Check the exhaust pipe supports.

    NOTICE:
    Install the exhaust pipe support onto the pipe retaining support.


2. INSTALL TAIL EXHAUST PIPE ASSEMBLY

A159349
  1. Install the 2 exhaust pipe supports.

  1. Install the tail exhaust pipe assembly and a new exhaust pipe gasket with the 2 compression springs and 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }

  1. A137397E01
    Check the exhaust pipe supports.

    NOTICE:
    Install the exhaust pipe support onto the pipe retaining support.


3. INSTALL HEATED OXYGEN SENSOR

  1. A158287E01
    Using SST, install the heated oxygen sensor onto the front exhaust pipe.
    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf }

  1. Pass the sensor connector through the floor panel and install the grommet.

  1. A158286
    Install the wire harness clamp bracket.

  1. A158285
    Connect the heated oxygen sensor connector.


4. INSTALL REAR CONSOLE BOX ASSEMBLY

C116873
  1. Engage the 2 clips and install the console box with the bolt.


5. INSTALL CONSOLE BOX CARPET

C109008
  1. Install the console box carpet.


6. INSTALL CONSOLE BOX REAR COVER

C109006E01
  1. Engage the 8 claws to install the console box rear cover.


7. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY

C109005E01
  1. Engage the 6 claws to install the shifting hole cover.


8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


10. INSPECT FOR EXHAUST GAS LEAK
← REMOVAL (from Nov 2006)ON-VEHICLE INSPECTION (from Aug 2005) →