REMOVAL
Removal / installation · Vehicles built from Nov 2006
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
|
| 3.
REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY
|
 |
Disengage the 6 claws and remove the shifting hole cover.
| 4.
REMOVE CONSOLE BOX REAR COVER
|
 |
Disengage the 8 claws and remove the console box rear cover.
| 5.
REMOVE CONSOLE BOX CARPET
|
 |
Remove the console box carpet.
| 6.
REMOVE REAR CONSOLE BOX ASSEMBLY
|
 |
Remove the bolt and disengage the 2 clips to remove the console box.
| 7.
REMOVE HEATED OXYGEN SENSOR
|
 |
- Disconnect the heated oxygen sensor connector.
Remove the grommet and pull the sensor connector out of the cabin through the floor panel.
- Remove the wire harness clamp bracket.
- Using SST, remove heated oxygen sensor.
- SST
- 09224-00010
| 8.
REMOVE TAIL EXHAUST PIPE ASSEMBLY |
 |
- Remove the 2 bolts and 2 compression springs.
Remove the 2 exhaust pipe supports and the tail exhaust pipe assembly.
| 9.
REMOVE FRONT EXHAUST PIPE ASSEMBLY |
 |
- Remove the 2 bolts and 2 compression springs.
- Remove the 3 exhaust pipe supports and the front exhaust pipe assembly.