REMOVAL
Removal / installation · Vehicles built from Nov 2006
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ENGINE UNDER COVER RH |
| 3. REMOVE NO. 2 CYLINDER HEAD COVER |
Disengage the 2 fittings shown in the illustration.

Disengage the 2 fittings shown in the illustration, then remove the No. 2 cylinder head cover.

| 4. REMOVE FAN AND GENERATOR V BELT |
Loosen bolts A and B.

Turn adjusting bolt C to release the tension and remove the V belt from the pulleys.
Remove the fan and generator V belt.
| 5. REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
Remove 2 bolts and remove the engine mounting stay RH .

Place a wooden block on a jack underneath the engine.

Remove the 6 bolts and nut and remove the engine mounting insulator sub-assembly RH.

| 6. REMOVE TRANSVERSE ENGINE ENGINE MOUNTING BRACKET |
Remove the 3 bolts and remove the engine mounting bracket.

| 7. REMOVE GENERATOR ASSEMBLY |
Remove the 2 bolts and remove the fan belt adjusting bar.

Remove the terminal cap.

Remove the nut and remove terminal B.
Disconnect the connector and harness clamp.
Remove the bolt and remove the generator assembly.

