2005-2008 Yaris · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2006


1. REMOVE GENERATOR CLUTCH PULLEY

  1. A163240
    Using a screwdriver, remove the generator pulley cap.

  1. A128069E01
    Set SST (A) and (B).
    SST
    09820-63020  

  1. Clamp SST (A) in a vise.

  1. A159979E01
    Place the rotor shaft end into SST (A).

  1. A159980E01
    Fit SST (B) onto the clutch pulley.

  1. A153377E02
    Loosen the pulley by turning SST (B) in the direction shown in the illustration.

  1. Remove the generator assembly from SST.

  1. Remove the clutch pulley from the rotor shaft.


2. REMOVE GENERATOR REAR END COVER

  1. A163759
    Place the generator assembly on the clutch pulley.

  1. A153379
    Remove the 3 nuts and generator rear end cover.


3. REMOVE GENERATOR TERMINAL INSULATOR

  1. A153380
    Remove the terminal insulator from the generator coil.


4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A153381
    Remove the 2 screws and brush holder from the generator coil.


5. REMOVE GENERATOR COIL ASSEMBLY

  1. A153382
    Remove the 4 bolts.

  1. A153383E01
    Using SST, remove the generator coil assembly.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)


6. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A118365
    Remove the generator washer.

  1. A153384
    Remove the generator rotor assembly.


7. REMOVE GENERATOR DRIVE END FRAME BEARING

  1. A153385
    Remove the 4 screws and bearing retainer from the drive end frame.

  1. A153386E01
    Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

← REMOVAL (from Nov 2006)INSPECTION (from Nov 2006) →