REMOVAL
Removal / installation · Vehicles built from Nov 2006
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 2 CYLINDER HEAD COVER |
Disengage the 2 fittings shown in the illustration.

Disengage the 2 fittings shown in the illustration, then remove the No. 2 cylinder head cover.

| 3. REMOVE DUTY VACUUM SWITCHING VALVE |
Disconnect the duty vacuum switching valve connector and wire harness clamp.

Remove the screw.

Disconnect the 2 hoses and remove the duty vacuum switching valve.
- NOTICE:
- Do not drop the duty vacuum switching valve during its removal.
