INSTALLATION
Removal / installation · Vehicles built from Nov 2006
| 1.
INSTALL HEATED OXYGEN SENSOR |
 |
- Using SST, install the heated oxygen sensor onto the front exhaust pipe.
- SST
- 09224-00010
-
Torque:
- 44 N*m{
449 kgf*cm
, 33 ft.*lbf
}
Pass the sensor connector through the floor panel and install the grommet.
- Install the wire harness clamp bracket.
- Connect the heated oxygen sensor connector.
| 2.
INSTALL REAR CONSOLE BOX ASSEMBLY
|
 |
Engage the 2 clips and install the console box with the bolt.
| 3.
INSTALL CONSOLE BOX CARPET
|
 |
Install the console box carpet.
| 4.
INSTALL CONSOLE BOX REAR COVER
|
 |
Engage the 8 claws to install the console box rear cover.
| 5.
INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY
|
 |
Engage the 6 claws to install the shifting hole cover.
| 6.
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
|
| 7.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
-
Torque:
- 5.4 N*m{
55 kgf*cm
, 48 ft.*lbf
}
| 8.
INSPECT FOR EXHAUST GAS LEAK |
|