REMOVAL
Removal / installation · Vehicles built from Nov 2006
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
| 3. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY |
![]() ![]() |
Disengage the 6 claws and remove the shifting hole cover.
| 4. REMOVE CONSOLE BOX REAR COVER |
![]() ![]() |
Disengage the 8 claws and remove the console box rear cover.
| 5. REMOVE CONSOLE BOX CARPET |
![]() ![]() |
Remove the console box carpet.
| 6. REMOVE REAR CONSOLE BOX ASSEMBLY |
![]() ![]() |
Remove the bolt and disengage the 2 clips to remove the console box.
| 7. REMOVE HEATED OXYGEN SENSOR |
Disconnect the heated oxygen sensor connector.

Remove the grommet and pull the sensor connector out of the cabin through the floor panel.
Remove the wire harness clamp bracket.

Using SST, remove heated oxygen sensor.

- SST
- 09224-00010




