2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2006


1. INSTALL STARTER ASSEMBLY

  1. A159355
    Install the starter assembly with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. A159354
    Connect the connector.

  1. Connect terminal 30 with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Close the terminal cap.


2. INSTALL FLYWHEEL HOUSING SIDE COVER

  1. A159356E01
    Insert the protruding portion into the end of the cylinder block and while pushing it along the cylinder block, fit the claw into the cylinder block.

    NOTICE:
    1. Make sure that the claw makes a click sound, indicating that it fits tightly.
    1. Replace the claw with a new one if it does not fit tightly or is deformed.


3. INSTALL ENGINE UNDER COVER RH

4. INSTALL ENGINE UNDER COVER LH

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REASSEMBLY (from Nov 2006)ON-VEHICLE INSPECTION (from Nov 2006) →