2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2006


1. INSTALL CAMSHAFT POSITION SENSOR

  1. A158220
    Apply a light coat of engine oil to the O-ring on the camshaft position sensor.

  1. A158218
    Install the camshaft position sensor with the bolt (for intake camshaft side).

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. A158219
    Install the camshaft position sensor with the bolt (for exhaust camshaft side).

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. A158217
    Connect the 3 engine wire harness clamps and duty vacuum switching connector (for LHD, exhaust camshaft side).


2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


3. INSPECT FOR OIL LEAK

4. INSTALL NO. 2 CYLINDER HEAD COVER

  1. A158207
    Disengage the 4 fittings shown and install the No. 2 cylinder head cover by applying pressure to it.

    HINT:
    Make sure that the oil and the engine oil level dipstick are correctly installed before installing the No. 2 cylinder head cover.

← REMOVAL (from Nov 2006)COMPONENTS (from Nov 2006) →