2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2006


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE NO. 2 CYLINDER HEAD COVER

  1. A163755
    Disengage the 2 fittings shown in the illustration.

  1. A163756
    Disengage the 2 fittings shown in the illustration, then remove the No. 2 cylinder head cover.


3. REMOVE CAMSHAFT POSITION SENSOR

  1. A158217
    Disconnect the duty vacuum switching valve connector and 3 engine wire harness clamps (for LHD, exhaust camshaft side).

  1. A158219
    Remove the bolt and remove the camshaft position sensor (for exhaust camshaft side).

  1. A158218
    Remove the bolt and remove the camshaft position sensor (for intake camshaft side).

← COMPONENTS (from Nov 2006)INSTALLATION (from Nov 2006) →