Removal / installation · Vehicles built from Nov 2006
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2.
DRAIN ENGINE COOLANT
NOTICE:
To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.
Loosen the radiator drain cock plug.
Remove the radiator cap sub-assembly.
Loosen the cylinder block drain cock plug, then drain the coolant.
3.
REMOVE NO. 2 CYLINDER HEAD COVER
Disengage the 2 fittings shown in the illustration.
Disengage the 2 fittings shown in the illustration, then remove the No. 2 cylinder head cover.
4.
REMOVE ENGINE COOLANT TEMPERATURE SENSOR
Disconnect the engine coolant temperature sensor connector.
Using SST, remove the engine coolant temperature sensor.