Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Sedan)

ANTI-LOCK BRAKE SYSTEM (for Sedan) > DTC CHECK / CLEAR

for Preparation Click here



DTC CHECK (USING INTELLIGENT TESTER)


  1. Check DTCs.



      A107926E08
    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Read the DTCs using the intelligent tester.
      Select the following menu items: Chassis / ABS/VSC/TRC/ DTC.


DTC CLEAR (USING INTELLIGENT TESTER)


  1. Clear the DTCs.



      A107926E08
    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Clear the DTCs using the intelligent tester.
      Select the following menu items: Chassis / ABS/VSC/TRC / DTC / Clear.


DTC CHECK (USING SST CHECK WIRE)


  1. Check DTCs.



      F100115E02
    1. Using SST, connect terminals TC and CG of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to ON.

    3. Read 2-digit DTCs indicated by the blinking of the ABS warning light on the combination meter.

      HINT:
      1. If the ABS warning light does not blink, perform relevant troubleshooting procedures. The relevant troubleshooting procedures are instructed in the sections listed in the table below.
        Section Title
        See Page
        ABS Warning Light does not Come ON
        Click here
        TC and CG Terminal Circuit
        Click here

      2. As an example, the blinking patterns of the normal system code and DTCs 11 and 21 are shown below.


        F100113E02

      3. DTCs are explained in "DIAGNOSTIC TROUBLE CODE CHART" (Click here).

    4. After completing the check, disconnect the SST from terminals TC and CG of the DLC3, and turn the ignition switch off.

      HINT:
      If 2 or more malfunctions are detected at the same time, the lowest numbered DTC is displayed first.


CLEAR DTC (USING SST CHECK WIRE)


  1. Clear the DTCs.



      F100115E02
    1. Using SST, connect terminals TC and CG of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to ON.



    3. BR03890
    4. Clear the DTCs stored in the skid control ECU by depressing the brake pedal 8 times or more within 5 seconds.

    5. Check that the warning light blinks in the normal system code pattern.

    6. Remove the SST from the terminals of the DLC3.

    7. Turn the ignition switch off.

      HINT:
      Clearing the DTCs cannot be performed by removing the battery cable or ECU-IG fuse.


END OF DTC CHECK/CLEAR
  1. Turn the ignition switch to ON.

  2. Check that the ABS warning light goes off within approximately 3 seconds.

  3. Turn the ignition switch off.