Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Sedan)

ANTI-LOCK BRAKE SYSTEM (for Sedan) > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the skid control ECU to display 2-digit DTCs by flashing the ABS warning light.

WIRING DIAGRAM


C118698E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - ECM)
  1. Turn the ignition switch off.

  1. Disconnect the ECM connector.



    C193487E01
  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    D15-13 (TC) - A21-27 (TC)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)


    F100115E26
  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    D15-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (ECM - BODY GROUND)
  1. Disconnect the ECM connector.



    C193488E01
  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    A21-27 (TC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE ECM
  1. Replace the ECM.

  1. Check for DTCs of the ECM (See page , Click here or Click here).

    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
A

END