DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P2102 | Conditions (a) and (b) continue for 2.0 seconds (1 trip detection logic): (a) Throttle actuator duty ratio 80 % or more (b) Throttle actuator current 0.2 A or less |
|
| P2103 | Either of following conditions met (1 trip detection logic):
|
|

| 1.INSPECT THROTTLE BODY ASSEMBLY (RESISTANCE OF THROTTLE ACTUATOR) |
![]() |
Disconnect the C17 throttle body connector.
Measure the resistance between the terminals of the throttle actuator.
| Tester Connections | Specified Conditions |
| M+ (2) - M- (1) | 0.3 to 100 Ω at 20°C (68°F) |
Reconnect the throttle body connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE ACTUATOR - ECM) |
![]() |
Disconnect the C17 throttle body connector.
Disconnect the C20 ECM connector.
Check the resistance.
| Tester Connections | Specified Conditions |
| M+ (C20-42) - M+ (C17-2) | Below 1 Ω |
| M- (C20-41) - M- (C17-1) |
| Tester Connections | Specified Conditions |
| M+ (C20-42) or M+ (C17-2) - Body ground | 10 kΩ or higher |
| M- (C20-41) or M- (C17-1) - Body ground |
Reconnect the throttle body connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 3.INSPECT THROTTLE BODY ASSEMBLY |
Check for foreign objects between the throttle valve and the housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE VALVE |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||