DTC P2118 Throttle Actuator Control Motor Current Range / Performance |

| DTC No. | DTC Detection Conditions | Trouble Areas |
| P2118 | Open in ETCS power source (+BM) circuit (1 trip detection logic) |
|

| 1.READ VALUE USING INTELLIGENT TESTER (+BM VOLTAGE) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / Data List / +BM voltage.
Read the value displayed on the tester.
|
| ||||
| NG | |
| 2.CHECK FUSE (ETCS FUSE) |
![]() |
Remove the ETCS fuse from the engine room relay block.
Check the ETCS fuse resistance.
Reinstall the ETCS fuse.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ECM - ETCS FUSE, ETCS FUSE - BATTERY) |
![]() |
Check the harness and connector between the ETCS fuse and ECM.
Remove the ETCS fuse from the engine room relay block.
Disconnect the A21 ECM connector.
Check the resistance.
| Tester Connections | Specified Conditions |
| ETCS fuse (2) - +BM (A21-3) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| ETCS fuse (2) or +BM (A21-3) - Body ground | 10 kΩ or higher |
Reinstall the ETCS fuse.
Reconnect the ECM connector.
Check the harness and connector between the ETCS fuse and positive battery cable.
Remove the ETCS fuse from the engine room relay block.
Disconnect the positive battery cable.
Check the resistance.
| Tester Connections | Specified Conditions |
| Positive battery cable - ETCS fuse (1) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| Positive battery cable or ETCS fuse (1) - Body ground | 10 kΩ or higher |
Reinstall the ETCS fuse.
Reconnect the positive battery cable.
|
| ||||
| OK | |
| Go to step 5 |
| 4.INSPECT ECM (+BM VOLTAGE) |
![]() |
Disconnect the A21 and C20 ECM connectors.
Measure the voltage between the terminals of the A21 and C20 ECM connectors.
| Tester Connections | Specified Conditions |
| +BM (A21-3) - E1 (C20-104) | 9 to 14 V |
Reconnect the ECM connectors.
|
| ||||
| OK | ||
| ||
| 5.INSPECT BATTERY |
Check that the battery is not depleted.
|
| ||||
| OK | |
| 6.CHECK BATTERY TERMINAL |
Check that the battery terminals and ECM ground are not loose or corroded.
|
| ||||
| OK | ||
| ||