Home › ENGINE ยท 1NZ-FE › FUEL › FUEL TANK

FUEL TANK > INSTALLATION

for Preparation Click here



1. CONNECT FUEL TANK BREATHER TUBE


A118755E01
  1. Connect the fuel tank breather tube with the clamp.

  1. Tighten the clamp bolt.



2. INSTALL FUEL EMISSION TUBE NO.2


A118747
  1. Install fuel emission tube No. 2 onto the fuel tank.



3. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY


A125130
  1. Install the fuel tank main tube onto the fuel tank.



4. INSTALL FUEL TANK ASSEMBLY


A105615
  1. Clean the bolt hole and remove any grease.

  1. Install the fuel tank with 4 new bolts.

    Torque:
    14 N*m{ 146 kgf*cm , 10 ft.*lbf }



5. CONNECT FUEL EMISSION TUBE NO. 2


A119220
  1. Connect fuel emission tube No. 2 with the clamp.



6. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


A109399
  1. Align the fuel tube connector with the pipe, push the fuel tube connector in until the retainer makes a click sound, then lock the cover of the connector.

    NOTICE:
    1. Check that there are no scratches or foreign matter on the disconnected parts of the fuel tube connector and pipe before performing this work.
    2. After connecting, pull the pipe and fuel tube connector to make sure that they are securely connected.



7. CONNECT FUEL TANK TO FILLER PIPE HOSE


A118742
  1. Connect the fuel tank to filler pipe hose with the clamp.

  1. Tighten the clamp bolt.



8. CONNECT FUEL TANK BREATHER HOSE


A118741
  1. Connect the fuel tank breather hose with the clamp.

  1. Tighten the clamp bolt.



9. INSTALL FUEL TANK COVER VENT CASE SUB-ASSEMBLY
  1. Install the fuel tank cover vent case with the bolt and clip

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



10. INSTALL FRONT FLOOR HEAT INSULATOR NO. 4
  1. Install front floor heat insulator No. 4 with the 2 nuts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



11. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
  1. Install the fuel suction with pump and gauge tube assembly (Click here).



12. ADD FUEL