DTC P0560 System Voltage |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0560 | Open in ECM back-up power source circuit (1 trip detection logic) |
|

| 1.CHECK FUSE (EFI FUSE) |
![]() |
Remove the EFI fuse from the engine room relay block.
Check the EFI fuse resistance.
Reinstall the EFI fuse.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - EFI FUSE, EFI FUSE - BATTERY) |
![]() |
Check the harness and the connector between the EFI fuse and ECM.
Remove the EFI fuse from the engine room relay block.
Disconnect the A21 ECM connector.
Check the resistance.
| Tester Connections | Specified Conditions |
| EFI fuse (2) - BATT (A21-20) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| EFI fuse (2) or BATT (A21-20) - Body ground | 10 kΩ or higher |
Reconnect the ECM connector.
Reinstall the EFI fuse.
Check the harness and the connector between the EFI fuse and battery.
Remove the EFI fuse from the engine room relay block.
Disconnect the positive battery terminal.
Check the resistance.
| Tester Connections | Specified Conditions |
| Battery positive terminal - EFI fuse (1) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| Battery positive terminal or EFI fuse (1) - Body ground | 10 kΩ or higher |
Reconnect the positive battery terminal.
Reinstall the EFI fuse.
|
| ||||
| OK | |
| 3.INSPECT BATTERY |
Check that the battery is not depleted.
|
| ||||
| OK | |
| 4.CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
|
| ||||
| OK | |
| 5.CHECK WHETHER DTC OUTPUT RECURS (DTC P0560) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Clear DTCs (Click here).
Turn the ignition switch off and turn the tester off.
Start the engine and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT/ DTC.
Read DTCs.
| Display (DTC Output) | Proceed To |
| P0560 | A |
| No output | B |
|
| ||||
| A | ||
| ||