Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY (for Hatchback)

CENTER AIRBAG SENSOR ASSEMBLY (for Hatchback) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Be sure to read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY


B106566
  1. Confirm that the ignition switch is turned to off.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    1. Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
    2. Do not start the operation for at least 90 seconds after disconnecting the negative battery terminal.

  1. Remove the 3 bolts and remove the airbag sensor.

    Torque:
    18 N*m{ 180 kgf*cm , 13 ft.*lbf }

    NOTICE:
    1. Do not use an airbag sensor that has been dropped.
    2. Do not subject the airbag sensor to any impact or force.
    3. Confirm that the carpet does not interfere with the installation plane.

  1. Confirm that there is no looseness by shaking the front airbag sensor.



    B106567E01
  1. Connect the connector holder to lock the lever.

    NOTICE:
    Confirm that the lever is locked.



    B106568
  1. Confirm that the drip-proof sheet has not been removed and does not cut into the connectors.



2. INSTALL CONSOLE BOX ASSEMBLY REAR


C116873
  1. Engage the 2 clips and install the console box with the bolt.



3. INSTALL CONSOLE BOX CARPET


C109008
  1. Install the console box carpet.



4. INSTALL CONSOLE BOX COVER REAR


C109006E01
  1. Engage the 8 claws to install the console box rear cover.



5. INSTALL FRONT ASH RECEPTACLE ASSEMBLY


6. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)


B208631
  1. Engage the 6 claws and install the shifting hole cover.



7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


B208628
  1. Install the shift lever knob.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



9. INSPECT SRS WARNING LIGHT
(Click here)