Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Check CAN Bus Line (RHD Models)

for Preparation Click here


DESCRIPTION

When any DTC for the CAN communication system is output, first measure the resistance between the terminals of the DLC3 to specify the trouble area, and check that there is no short in the CAN main wire, between the main wire, to +B, or to GND.

WIRING DIAGRAM


E191970E02


INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.CHECK CAN BUS WIRE (MAIN WIRE FOR DISCONNECTION, CAN BUS LINES FOR SHORT CIRCUIT)


    E191939E02
  1. Turn the ignition switch off.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    Proceed to
    D15-6 (CANH) - D15-14 (CANL)
    Ignition switch off
    54 to 69 Ω
    OK
    D15-6 (CANH) - D15-14 (CANL)
    Ignition switch off
    69 Ω or higher
    NG-A
    D16-6 (CANH) - D15-14 (CANL)
    Ignition switch off
    54 Ω or less
    NG-B

    Text in Illustration 
    *1
    DLC3



NG-A
CHECK CAN MAIN WIRE FOR DISCONNECTION (Click here)

NG-B
CHECK CAN BUS LINES FOR SHORT CIRCUIT (Click here)
OK


2.CHECK CAN BUS LINE FOR SHORT TO +B


    E191939E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D15-6 (CANH) - D15-16 (BAT)
    Ignition switch off
    6 kΩ or higher
    D15-14 (CANL) - D15-16 (BAT)
    Ignition switch off
    6 kΩ or higher

    Text in Illustration 
    *1
    DLC3



NG
CHECK CAN BUS LINE FOR SHORT TO +B (Click here)
OK


3.CHECK CAN BUS LINE FOR SHORT TO GND


    E191939E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D15-6 (CANH) - D15-4 (CG)
    Ignition switch off
    200 Ω or higher
    D15-14 (CANL) - D15-4 (CG)
    Ignition switch off
    200 Ω or higher

    Text in Illustration 
    *1
    DLC3



NG
CHECK CAN BUS LINE FOR SHORT TO GND (Click here)
OK

HOW TO PROCEED WITH TROUBLESHOOTING (Click here)