Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT AIRBAG SENSOR (for Hatchback)

FRONT AIRBAG SENSOR (for Hatchback) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the LH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.



1. INSTALL AIRBAG SENSOR FRONT LH


B106583

NOTICE:
  1. Do not use a front airbag sensor that has been dropped.
  2. Do not subject the front airbag sensor any impact or force.

  1. Confirm that the ignition switch is turned to off.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    1. Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
    2. Do not start the operation for at least 90 seconds after disconnecting the negative battery terminal.



  1. Connect the airbag connector.

    1. Check that the CPA is in the provisionally locked condition.



    2. B106584E01
    3. Push the CPA until it makes a click sound.

      NOTICE:
      1. Engage the connector by pushing it straight.
      2. Hold the CPA when engaging the connector.
      3. Do not engage the CPA while pressing the CPA upper portion, otherwise, the half connection prevention mechanism will not function.

    4. Confirm that the rear side of the housing and the CPA rear surface are tightly fitted together.



    B106581E01
  1. Install the front airbag sensor with the 2 bolts.

    Torque:
    9.0 N*m{ 90 kgf*cm , 80 in.*lbf }

  1. Confirm that there is no looseness by shaking the front airbag sensor.



2. INSTALL FRONT BUMPER COVER


    B114362
  1. Install the 2 clips and the screw grommet.



    B185295
  1. Engage the 6 claws and install the front bumper cover.

  1. Connect the 2 connectors.

    HINT:
    If the vehicle is equipped with fog lights, connect the connector.



    B209559
  1. Install the 7 clips.

  1. Install the 2 screw grommets.

  1. Tighten the 8 screws.



    B185052E01
  1. Remove the protective tape.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



4. INSPECT SRS WARNING LIGHT
(Click here)