Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > ECM Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
  1. "Engine" not displayed on "Communication Bus Check" of intelligent tester
  2. Applies to "ECM Communication Stop Mode" in "DTC combination table"
  1. Power source circuit of ECM
  2. ECM main wire or connector
  3. ECM

WIRING DIAGRAM


C126001E13


INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.INSPECT ECM POWER SOURCE CIRCUIT
  1. 1NZ-FE engine:

    1. Inspect the power source circuit (Click here).

  1. 2NZ-FE engine:

    1. Inspect the power source circuit (Click here).



NG
GO TO POWER SOURCE CIRCUIT
OK

REPLACE ECM