Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Sedan)

ANTI-LOCK BRAKE SYSTEM (for Sedan) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The anti-lock brake system troubleshooting procedures are based on the premise that the CAN communication system is normally functioning. Check the CAN communication system first before troubleshooting the vehicle stability control system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer and confirm the trouble.


    NEXT


    3.CHECK DTC AND FREEZE FRAME DATA*
    1. Check and record DTC and Freeze Frame Data.

    2. Clear the DTC and Freeze Frame Data (Click here for DTC Check/Clear, or Click here for Freeze Frame Data).

    3. Reconfirm the DTC.

      1. Reconfirm the DTC based on the recorded DTC and Freeze Frame Data (Click here for DTC Check/Clear, or Click here for Freeze Frame Data).
        Result 
        Result
        Proceed to
        DTC output
        A
        DTC not output (Problem symptom does not occur)
        B
        DTC not output (Problem symptom occurs)
        C



    B.
    GO TO STEP 5

    C.
    GO TO STEP 6
    A


    4.DIAGNOSTIC TROUBLE CODE CHART
    1. Proceed to Diagnostic Trouble Code Chart (Click here).


    NEXT

    GO TO STEP 7


    5.SYMPTOM SIMULATION
    1. Proceed to Check for Intermittent Problems (Click here).


    NEXT


    6.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).


    NEXT


    7.CIRCUIT INSPECTION*

      NEXT


      8.IDENTIFICATION OF PROBLEM

        NEXT


        9.REPAIR OR REPLACEMENT

          NEXT


          10.CONFIRMATION TEST*

            NEXT

            END