Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Hatchback)

ANTI-LOCK BRAKE SYSTEM (for Hatchback) > FREEZE FRAME DATA

for Preparation Click here



FREEZE FRAME DATA
  1. Whenever a DTC is detected, the skid control ECU stores the current vehicle (sensor) state as Freeze Frame Data.

  2. The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from OFF to ON since the last time the ABS was activated.

    HINT:
    1. However, if the vehicle is stopped or at a low speed (7 km/h (4.3 mph) or less), or if a DTC is detected, the skid control ECU will stop counting the number.
    2. Freeze Frame Data at the time the ABS operates:
      The skid control ECU stores and updates data whenever the ABS system operates.
      When the ECU stores data at the time a DTC is detected, the data stored during ABS operation is cleared.
    3. Freeze Frame Data at the time a DTC is detected:
      When the skid control ECU stores data at the time a DTC is detected, no updates will be performed until the data is cleared.


CHECK FREEZE FRAME DATA
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester on.

  4. Check the freeze frame data by following the prompts on the intelligent tester display.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item
    Reference Value
    Elapsed Time after Freeze Trigger
    Elapsed time after freeze trigger
    Min.: 0 ms, Max.: 500 ms
    Number of IG ON
    Number of operations of ignition switch being turned to ON after storing Freeze Frame Data
    0 to 31
    Stop Light SW
    Stop light switch signal
    Stop light switch ON: ON, OFF: OFF
    Parking Brake SW
    Parking brake switch signal
    Parking brake switch ON: ON, OFF: OFF
    Operated System
    Operated system status
    ABS activated: ABS
    Fail-safe mode activated: FAIL
    System prohibit activated: SYS
    No operation activated: NON
    Forward and Rearward G
    Forward and Rearward G
    Min.: -25.11 m/sec.2, Max.: 24.91 m/sec.2
    FR Wheel Speed
    FR wheel speed
    Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
    FL Wheel Speed
    FL wheel speed
    Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
    RR Wheel Speed
    RR wheel speed
    Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
    RL Wheel Speed
    RL wheel speed
    Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
    Vehicle Speed
    Vehicle speed reading
    Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
    Vehicle Speed Grade
    Vehicle speed grade
    Min.: -25.11 m/s2, Max.: 24.91 m/s2


CLEAR FREEZE FRAME DATA

NOTICE:
Clearing the DTC will also clear the Freeze Frame Data.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Clear the DTC and Freeze Frame Data (Click here).