Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Hatchback)

ANTI-LOCK BRAKE SYSTEM (for Hatchback) > DTC CHECK / CLEAR

for Preparation Click here



DTC CHECK/CLEAR (Using Intelligent Tester)
  1. Check the DTC.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.

      HINT:
      Refer to the intelligent tester operator's manual for further details.

  2. Clear the DTC.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.

    4. Clear the DTCs by following the prompts on the intelligent tester.

      HINT:
      Refer to the intelligent tester operator's manual for further details.


DTC CHECK/CLEAR (for Using SST Check Wire)


    F100115E86
  1. Check the DTC.

    1. Using SST, connect terminals TC and CG of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to ON.

    3. Observe the blinking pattern of the ABS warning light in order to identify the DTC.

      HINT:
      If no code appears, inspect the TC and CG terminal circuit and ABS warning light circuit.

      Trouble Area
      See procedure
      ABS warning light circuit (Remains on)
      Click here
      ABS warning light circuit (Does not come on)
      Click here
      TC and CG terminal circuit
      Click here



    4. As an example, the illustration below shows the blinking patterns of the normal system code and trouble codes 11 and 21 for ABS warning light.


      F100113E07

    5. The codes are explained in the code table.

      Code Table 
      ABS Warning Light Number of Blinks
      Intelligent Tester Display
      11
      C0278
      12
      C0279
      13
      C0273
      14
      C0274
      21
      C0226
      22
      C0236
      23
      C0246
      24
      C0256
      31
      C1401
      C1405
      32
      C1402
      C1406
      33
      C1403
      C1407
      34
      C1404
      C1408
      35
      C1413
      36
      C1414
      38
      C1415
      39
      C1416
      41
      C1241
      C1417
      49
      C1425
      51
      C1427
      C1428
      94
      U0073

    6. After completing the check, disconnect terminals TC and CG of the DLC3.

      HINT:
      If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.



  2. Clear the DTC.



      F100115E86
    1. Using SST, connect terminals TC and CG of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to ON.



    3. BR03890
    4. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

    5. Check that the warning light indicates a normal system code.

    6. Remove SST from the terminals of the DLC3.

      HINT:
      Clearing the DTCs cannot be performed by disconnecting the battery terminal or the ECU-IG fuse.


END OF DTC CHECK/CLEAR
  1. Turn the ignition switch to ON.

  2. Check that the ABS warning light goes off within approximately 3 seconds.