ANTI-LOCK BRAKE SYSTEM (for Sedan) > ABS Warning Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK ABS WARNING LIGHT |
Disconnect the A76 brake actuator assembly (skid control ECU) connector.
Turn the ignition switch to ON.
Check that the ABS warning light comes on.
Reconnect the A76 brake actuator assembly (skid control ECU) connector.
|
| ||||
| OK | ||
| ||
| 3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (Indicat. Lamp ABS) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body / Combination Meter / Active Test.
According to the display on the tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp ABS | ABS warning light | OFF/ON | Perform the test with the vehicle stopped and the engine idling |
Check that the ABS warning light on the combination meter turns on or off in accordance with the tester operation.
|
| ||||
| OK | ||
| ||