DTC P0340 Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0340 | Case 1
(1 trip detection logic *2) Case 2
|
|

| Items | Contents |
| Terminals | CH1: G2+ - NE- CH2: NE+ - NE- |
| Equipment Settings | 5 V/Division, 20 ms./Division |
| Conditions | Cranking or idling |
| 1.INSPECT CAMSHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the C18 Camshaft Position (CMP) sensor connector.
Measure the resistance between terminals 1 and 2.
| Tester Connections | Conditions | Specified Conditions |
| 1 - 2 | Cold | 1,630 to 2,740 Ω |
| 1 - 2 | Hot | 2,065 to 3,225 Ω |
Reconnect the CMP sensor connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the C18 CMP sensor connector.
Disconnect the C20 ECM connector.
Check the resistance.
| Tester Connections | Specified Conditions |
| G2+ (C18-1) - G2+ (C20-99) | Below 1 Ω |
| NE- (C18-2) - NE- (C20-121) |
| Tester Connections | Specified Conditions |
| G2+ (C18-1) or G2+ (C20-99) - Body ground | 10 kΩ or higher |
| NE- (C18-2) or NE- (C20-121) - Body ground |
Reconnect the ECM connector.
Reconnect the CMP sensor connector.
|
| ||||
| OK | |
| 3.CHECK SENSOR INSTALLATION (CAMSHAFT POSITION SENSOR) |
![]() |
Check the CMP sensor installation.
|
| ||||
| OK | |
| 4.CHECK VALVE TIMING |
![]() |
Remove the cylinder head cover.
Turn the crankshaft pulley, and align its groove with the timing mark "0" on the timing chain cover.
Check that the timing marks on the camshaft timing sprocket and camshaft timing gear are facing upward as shown in the illustration.
Reinstall the cylinder head cover.
|
| ||||
| OK | |
| 5.CHECK CAMSHAFT |
Check the teeth of the camshaft.
|
| ||||
| OK | |
| 6.REPLACE CAMSHAFT POSITION SENSOR |
| NEXT | |
| 7.CHECK WHETHER DTC OUTPUT RECURS (DTC P0340) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Clear DTCs (Click here).
Start the engine.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Read DTCs.
| Display (DTC Output) | Proceed To |
| No output | A |
| P0340 | B |
|
| ||||
| A | ||
| ||