Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH (for Sedan)

STEERING PAD SWITCH (for Sedan) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here ).



1. INSTALL STEERING PAD SWITCH LH
  1. Engage the 2 claws and the pin.

  1. Install the steering pad switch LH with the screw.

  1. Connect the connector.



2. INSTALL STEERING PAD ASSEMBLY


C117196E01

NOTICE:
Do not use a steering pad that has been dropped.

  1. Confirm that the ignition switch is turned to OFF.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    Do not begin the operation for at least 90 seconds after the negative battery terminal is detached.

  1. Connect the horn terminal.

  1. Connect the airbag connector.

    NOTICE:
    1. Match the color of the airbag connector with that of the steering pad assembly, and install the airbag connector.
    2. Securely lock the locking button.



    C139083
  1. Install the steering pad.

  1. Using "TORX" socket wrench T30, tighten the 2 bolts.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }

    NOTICE:
    Tighten the 2 bolts while holding the steering pad to prevent it moving upward.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



4. INSPECT SRS WARNING LIGHT
(Click here)