Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

ELECTRONIC POWER STEERING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


Perform troubleshooting according to the following flowchart.

HINT:
For further details, see the page given.
The intelligent tester can be used at steps 3, 4, 7, 10 and 13.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CHECK DTC AND FREEZE FRAME DATA
      1. Record DTCs and freeze frame data (Click here ).


      NEXT


      4.CLEAR DTC AND FREEZE FRAME DATA

        HINT:
        Clear DTC and FREEZE FRAME DATA (Click here ).


      NEXT


      5.PROBLEM SYMPTOM CONFIRMATION


        .
        SYMPTOM DOES NOT OCCUR: GO TO STEP 6

        .
        SYMPTOM OCCURS: GO TO STEP 7

        6.SYMPTOM SIMULATION

          NEXT


          7.CHECK DTC
          1. Recheck for DTCs (Click here ).

          2. HINT:
            1. Refer to the diagnostic trouble code chart when any DTCs are output.
            2. When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
            3. When communication to the power steering ECU is not established through the intelligent tester, inspect terminals SIL of the DLC3 and the power steering ECU, and the IG circuit of the power steering ECU.



          .
          NORMAL SYSTEM CODE OUTPUT: GO TO STEP 8

          .
          DTC OUTPUT: GO TO STEP 9

          8.PROBLEM SYMPTOMS TABLE

            HINT:
            Refer to PROBLEM SYMPTOMS TABLE.


          NEXT


          9.DTC CHART

            HINT:
            Refer to DIAGNOSTIC TROUBLE CODE CHART (Click here).


          NEXT


          10.CIRCUIT INSPECTION

            NEXT


            11.PROBLEM IDENTIFICATION

              NEXT


              12.REPAIR OR REPLACE

                NEXT


                13.CONFIRMATION TEST

                  NEXT

                  END