Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

ELECTRONIC POWER STEERING SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC


    A107926E18
    C141211E01
  1. When using an intelligent tester;

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Read the DTCs by following the prompts on the intelligent tester.

      HINT:
      Refer to the intelligent tester operator's manual for further details.



  2. F100115E02
  3. When not using an intelligent tester;

    1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to ON.



    3. F040045E02
    4. Read and write down any DTCs indicated by the P/S warning light on the combination meter. Refer to the chart on the left for examples of a normal code and DTCs 21 and 22.

      HINT:
      1. If the P/S warning light does not blink to display any DTCs set or the normal code, inspect the circuit shown in the table below.
        Trouble Area
        See Page
        EPS warning light circuit
        Click here
      2. If two or more malfunctions are detected simultaneously, DTCs will be displayed in ascending numerical order.

    5. Refer to the Diagnostic Trouble Code Chart (Click here ) for DTC information.


CLEAR DTC
  1. When using an intelligent tester;

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Clear the DTCs by following the prompts on the intelligent tester.

    5. Turn the ignition switch off.

    6. Disconnect the intelligent tester from the DLC3.



  2. F100115E29
  3. When not using an intelligent tester;

    1. Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to ON.

    3. Disconnect the SST check wire from terminal 4 (CG) and reconnect it, and repeat this procedure 4 times or more within 8 seconds.

    4. Check that the P/S warning light blinks a code to indicate normality.

    5. Turn the ignition switch off.

    6. Remove the SST from the DLC3.