Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

ELECTRONIC POWER STEERING SYSTEM > EPS Warning Light Circuit

for Preparation Click here


DESCRIPTION

If the power steering ECU detects a malfunction, the P/S warning light comes on. At this time, the power steering ECU stores a DTC in its memory.

WIRING DIAGRAM


C186115E02


INSPECTION PROCEDURE

1.INSPECT CAN COMMUNICATION SYSTEM
  1. Using the intelligent tester, check for DTCs and confirm that there are no problems in the CAN communication system.

    OK:
    DTCs are not output.



NG
GO TO CAN COMMUNICATION SYSTEM
OK


2.READ VALUE USING DATA LIST (IG POWER SUPPLY)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item IG Power Supply in the Data List and read the value displayed on the intelligent tester.

    Standard Voltage:
    11 to 14 V

    HINT:
    If the voltage is not standard value, inspect IG power source circuit (Click here ).



NG
INSPECT POWER SOURCE CIRCUIT (IG)
OK


3.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND)
C162262E05
  1. Disconnect the connectors from the power steering ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    D31-6 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    A19-2 (PGND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE POWER STEERING ECU
  1. Replace the power steering ECU.

NOTICE:
After replacing the power steering ECU, perform the torque sensor zero point calibration.


NEXT


5.CHECK P/S WARNING LIGHT (COMBINATION METER)
  1. Check that the P/S warning light on the combination meter does not come on.

    OK:
    The P/S warning light does not come on.



NG
REPLACE COMBINATION METER
OK

END