Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

DTC    B1620/21    Driver Side - Side Airbag Sensor Circuit Malfunction

DTC    B1622/81    Lost Communication with Driver Side - Side Airbag Sensor Assembly

for Preparation Click here


DESCRIPTION

for DTC B1620/21:
The side airbag sensor LH and RH consists of the diagnostic circuit, the lateral deceleration sensor, etc.
If the center airbag sensor assembly receives signals from the lateral deceleration sensor, it determines whether the SRS should be activated.
DTC B1620/21 is recorded when a malfunction is detected in the side airbag sensor LH or RH circuit.
for DTC B1622/81:
The circuit for the side collision sensor LH or RH (to determine deployment of the front seat side airbag LH or RH, and curtain shield airbag LH or RH) is composed of the center airbag sensor assembly, side airbag sensor LH or RH, and rear airbag sensor LH or RH.
The side airbag sensor LH or RH, and rear airbag sensor LH or RH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbag should be deployed.
DTC B1622/81 is recorded when a malfunction is detected in the circuit for the side collision sensor LH or RH (to determine deployment of the front seat side airbag LH or RH, and curtain shield airbag LH or RH).

DTC Code
Detecting Condition
Trouble Area
B1620/21
B1622/81
  1. Center airbag sensor assembly detects open circuit signal in driver side - side airbag sensor circuit for 2 seconds.
  2. Driver side - side airbag sensor malfunction
  3. Center airbag sensor assembly malfunction
  1. Side airbag sensor LH (Driver side-side airbag sensor) (LHD)
    Side airbag sensor RH (Driver side-side airbag sensor) (RHD)
  2. Center airbag sensor assembly

WIRING DIAGRAM


C148422E23


C148422E24


INSPECTION PROCEDURE

NOTICE:
In order to prevent unexpected airbag deployment, disconnect the following connectors before inspecting parts such as wire harnesses, if the application of tester probes to the center airbag sensor assembly connector is necessary.

  1. Turn the ignition switch off.
  2. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
  3. Disconnect the connector from the center airbag sensor assembly.
  4. Disconnect the connector from the steering pad.
  5. Disconnect the connector from the front seat outer belt assembly LH.
  6. Disconnect the connector from the front seat outer belt assembly RH.

    HINT:
    Skip the following steps if side airbags, curtain shield airbags, front passenger airbag and a knee airbag are not fitted.

  7. Disconnect the connector from the front passenger airbag assembly.
  8. Disconnect the connector from the front seat side airbag assembly LH.
  9. Disconnect the connector from the front seat side airbag assembly RH.
  10. Disconnect the connector from the curtain shield airbag assembly LH.
  11. Disconnect the connector from the curtain shield airbag assembly RH.
  12. Disconnect the connector from the driver side knee airbag assembly.
1.CHECK DRIVER SIDE - SIDE AIRBAG SENSOR
C158834E06
  1. Turn the ignition switch off.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Interchange the front passenger side - side airbag sensor with the driver side - side airbag sensor and connect the connectors to them.

  1. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Clear the DTCs stored in the memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1620, B1622, B1625 and B1627 are not output.
    A
    DTC B1625 or B1627 is output.
    B
    DTC B1620 or B1622 is output.
    C

    HINT:
    Codes other than DTC B1620, B1622, B1625 and B1627 may be output at this time, but they are not related to this check.



A
USE SIMULATION METHOD TO CHECK (Click here)

B
REPLACE DRIVER SIDE - SIDE AIRBAG SENSOR
C

REPLACE CENTER AIRBAG SENSOR ASSEMBLY