Home › BRAKE › BRAKE CONTROL › FRONT SPEED SENSOR (for Sedan)

FRONT SPEED SENSOR (for Sedan) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SPEED SENSOR



C121848

  1. Install the speed sensor onto the steering knuckle with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    1. Check that the speed sensor tip and installation portion are free of foreign matter.
    2. Install the speed sensor without turning it from its original installation angle.

  1. Install the clamp onto the shock absorber with the bolt.

    Torque:
    29 N*m{ 300 kgf*cm , 22 ft.*lbf }

  1. Install the clamp onto the body with the bolt.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Install the 3 clips.

  1. Connect the speed sensor connector.

  1. Install the speed sensor clip onto the body.



2. INSTALL FRONT FENDER LINER
  1. Install the front fender liner with the 3 screws, 6 clips and 4 grommets.

    NOTICE:
    The speed sensor wire should not protrude beyond the front fender liner.



3. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



5. CHECK VSC SENSOR SIGNAL (w/ VSC)
(Click here)


6. CHECK ABS SENSOR SIGNAL (w/o VSC)
(Click here)