Home › BRAKE › BRAKE CONTROL › SKID CONTROL SENSOR (for Hatchback)

SKID CONTROL SENSOR (for Hatchback) > INSTALLATION

for Preparation Click here



1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


    C121821
  1. Install the axle hub and bearing onto the axle beam with the 4 bolts.

    Torque:
    90 N*m{ 918 kgf*cm , 67 ft.*lbf }



2. INSPECT REAR AXLE HUB BEARING
  1. Remove the rear wheel.

  1. Remove the rear brake drum .



    C121815
  1. Inspect the axle hub and bearing backlash.

    1. Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash exceeds the maximum, replace the axle hub and bearing.



    C121816
  1. Inspect the axle hub and bearing runout.

    1. Using a dial indicator, check the runout of the surface of the axle hub.

      Maximum:
      0.07 mm (0.0028 in.)

      If the runout exceeds the maximum, replace the axle hub and bearing.

  1. Install the rear brake drum.

  1. Adjust the rear drum brake shoe clearance .

  1. Install the rear wheel.

    Torque:
    103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



3. CONNECT SKID CONTROL SENSOR WIRE


    C107565
  1. Connect the skid control sensor wire connector.



4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY


5. ADJUST REAR DRUM BRAKE SHOE CLEARANCE


F040023E03
  1. Provisionally install the 2 hub nuts.

  1. Remove the hole plug, and turn the adjuster to expand the shoe until the drum locks.

  1. Using a screwdriver, release the adjuster 12 notches.

  1. Install the hole plug.



6. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



8. CHECK VSC SENSOR SIGNAL (w/ VSC)
(Click here)


9. CHECK ABS SENSOR SIGNAL (w/o VSC)
(Click here)