Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Sedan)

DTC    C1251/51    Open in Pump Motor Circuit

for Preparation Click here


DESCRIPTION

The motor relay (semiconductor relay) is housed in the skid control ECU and drives the pump motor based on a signal from the skid control ECU.

DTC No.
DTC Detecting Conditions
Trouble Areas
C1251/51
When either of following conditions detected:
  1. Actuator pump motor does not operate properly.
  2. Open in actuator pump motor circuit continues for at least 2 seconds.
Brake actuator

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

1.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Drive the vehicle at a speed of 6 km/h (4 mph) or more for several seconds.

  1. Check if the same DTC is output (Click here ).

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE BRAKE ACTUATOR