Home › STEERING › POWER STEERING › POWER STEERING ECU (for Sedan)

POWER STEERING ECU (for Sedan) > INSTALLATION

for Preparation Click here



1. INSTALL POWER STEERING ECU


    C118008
  1. Install the power steering ECU with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



    C117190
  1. Connect the 4 connectors.



    C117191
  1. Install the wire harness clamp.

    NOTICE:
    Make sure that the wire harness of the steering post assembly is installed onto the power steering ECU bracket and that it is not pulled too tightly.



2. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
  1. Install the upper instrument panel sub-assembly (Click here).



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



4. CHECK SRS WARNING LIGHT
(Click here)


5. PERFORM ZERO POINT CALIBRATION
(Click here)