IGNITION SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT IGNITION COIL AND SPARK TEST |
Check for DTCs.
Check whether sparks occur.
Remove cylinder head cover No. 2 .
Remove the 4 ignition coils .
Using a 16 mm (0.63 in) plug wrench, remove the 4 spark plugs.
Install the spark plug onto each ignition coil and connect the ignition coil connectors.
Disconnect the 4 injector connectors.
Ground the spark plugs.
Check that sparks occur while the engine is being cranked.
Perform the spark test in accordance with the following procedure.
Check that the wire harness side connector of the ignition coil with igniter is securely connected.
| Result | Proceed to |
| NG | Connect securely |
| OK | Go to next step |
Perform a spark test on each ignition coil with igniter.
| Result | Proceed to |
| OK | Replace ignition coil with igniter |
| NG | Go to next step |
Check the power supply to ignition coil with igniter.
| Result | Proceed to |
| NG | Check wiring between engine switch and ignition coil with igniter |
| OK | Go to next step |
Check the resistance of camshaft position sensor.
| Temperature | Specified Condition |
| Cold | 1,630 to 2,740 Ω |
| Hot | 2,065 to 3,225 Ω |
| Result | Proceed to |
| NG | Replace camshaft position sensor |
| OK | Go to next step |
Check the resistance of the crankshaft position sensor.
| Temperature | Specified Condition |
| Cold | 985 to 1,600 Ω |
| Hot | 1,265 to 1,890 Ω |
| Result | Proceed to |
| NG | Replace crankshaft position sensor |
| OK | Go to next step |
Check the IGT from the ECM (Click here).
| Result | Proceed to |
| NG | Check ECM |
| OK | Repair wiring between ignition coil and ECM |
Connect the 4 injector connectors.
Using a 16 mm (0.63 in) plug wrench, install the 4 spark plugs.
Install the 4 ignition coils .
Install cylinder head cover No. 2 .
| 2. INSPECT SPARK PLUG |
![]() |
Check the electrode.
Using a megaohmmeter, measure the insulation resistance.
Alternative inspection method.
Quickly accelerate the engine to 4,000 rpm 5 times.
Remove the spark plug.
![]() |
Visually check the spark plug.
If the electrode is dry, the spark plug is functioning properly. If the electrode is damp, proceed to the next step.
Check the spark plug for any damage on its thread and insulator.
If there is damage, replace the spark plug.
| Manufacturer | Product |
| DENSO | K16R-U |
| NGK | BKR5EYA |
![]() |
Check the spark plug electrode gap.
![]() |
Clean the spark plugs.
If the electrode has traces of wet carbon, clean the electrode with a spark plug cleaner and then dry it.