Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM (for Hatchback)

METER / GAUGE SYSTEM (for Hatchback) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the combination meter.
  2. Use the intelligent tester in steps 3 and 5.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK CAN COMMUNICATION SYSTEM
    1. Use an intelligent tester to check if the CAN communication system is functioning normally.

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    Go to CAN COMMUNICATION SYSTEM
    A


    4.PROBLEM SYMPTOMS TABLE

      Result:
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to STEP 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here )

    2. Data List / Active Test (Click here )

    3. On-vehicle Inspection (Click here )


    NEXT


    6.ADJUST, REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END