Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the air conditioning system.
  2. Use the intelligent tester in steps 4, 5 and 7.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

      NEXT


      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.

      NEXT


      4.CHECK CAN COMMUNICATION SYSTEM
      1. Use an intelligent tester to check if the CAN communication system is functioning.

        Result:
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output
        B



      B.
      Go to CAN COMMUNICATION SYSTEM
      A


      5.CHECK DTC
      1. Check for DTCs and write down any DTCs that are output.

      2. Clear the DTCs.

      3. Recheck for DTCs. Based on the DTCs output above, try to cause output of the A/C system DTC by simulating the operation indicated by the DTC.

        Result:
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      B.
      Go to STEP 8
      A


      6.REFER TO PROBLEM SYMPTOMS TABLE
      1. Problem symptoms table (Click here)


      2. Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      Go to STEP 8
      A


      7.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. Data List / Active Test (Click here).

      2. Terminals of ECU (Click here).


      NEXT


      8.ADJUST, REPAIR OR REPLACE

        NEXT


        9.CONFIRMATION TEST

          NEXT

          END