Home › RESTRAINTS › SEAT BELT › OCCUPANT DETECTION SENSOR (for Hatchback)

OCCUPANT DETECTION SENSOR (for Hatchback) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

NOTICE:
Always use "TORX" socket wrench E10 when installing the front seat.

HINT:
The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.



1. INSTALL FRONT SEAT CUSHION COVER PAD (Built in Occupant Detection Sensor)


    B209763
  1. Connect the seat heater connector.

  1. Engage the 2 claws and the 9 hooks and install the front seat cushion cover pad.

  1. Install the occupant detection sensor connector.



    B114700E02
  1. w/ Front Seat Side Airbag:

    1. Fix the front seat side airbag wiring harness with the front seat cushion cover pad fixing cover.

  1. for Clip Type:

    1. Install the 2 clips.

  1. for J Hook Type:

    1. Engage the 2 hooks.



    B119875
  1. Install the front seatback cover band.



2. INSTALL FRONT SEAT CUSHION SHIELD LH


    B121711
  1. Engage the claw and the clip and install the front seat cushion shield.

  1. Tighten the screw.



3. INSTALL FRONT SEAT INNER BELT ASSEMBLY


    B114763E01
  1. Install the front seat inner belt with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.

  1. Install the wiring harness onto the claw of the front seat cushion shield.



    B209774
  1. Install the 5 wiring harness clamps.

  1. Install the buckle switch connector.

  1. Connect the occupant detection sensor connector.

  1. Engage the 2 hooks and install the front seat cushion cover pad.



4. INSTALL FRONT SEAT CUSHION SHIELD RH


    B121710
  1. Engage the 2 claws and the clip and install the front seat cushion shield.

  1. Tighten the screw.



5. INSTALL RECLINING ADJUSTER RELEASE HANDLE


    B121712
  1. Engage the claw and install the reclining adjuster release handle.



6. INSTALL FRONT SEAT ASSEMBLY

HINT:
Use the same procedure as for the driver side .



7. INSTALL FRONT SEAT UNDER TRAY (w/ Under Tray)


    B119884
  1. Hitch the front seat under tray firmly onto the seat track, and then slide it along the seat track to install it.



8. INSTALL FRONT SEAT HEADREST ASSEMBLY


    B138677E01
  1. Push in the 2 lock buttons of the front seat headrest supports and install the 2 front seat headrests.



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



10. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)