FRONT SEAT OUTER BELT ASSEMBLY (for Hatchback 5 Door) > DISPOSAL |
| 1. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (When Installed in Vehicle) |
![]() |
Check whether SST is functioning.
![]() |
Connect the SST red clip to the positive battery terminal and the black clip to the negative battery terminal.
![]() |
Press the SST activation switch and check that the LED of the SST activation switch illuminates.
Disconnect SST from the battery.
Disconnect the pretensioner connector.
Disconnect the cable from the negative battery terminal.
Remove the front door scuff plate .
Remove the rear door scuff plate .
![]() |
Remove the front door opening trim weatherstrip.
![]() |
Remove the rear door opening trim weatherstrip.
Remove the center pillar lower garnish .
![]() |
Disconnect the pretensioner connector as shown in the illustration.
![]() |
Connect SST.
Connect SST, then connect the yellow connector to the seat belt pretensioner.
![]() |
Connect SST.
Move SST at least 10 m (33 ft) away from the front of the vehicle.
Close the doors and windows of the vehicle.
Connect the SST red clip to the positive battery terminal and the black clip to the negative battery terminal.
Activate the seat belt pretensioner.
Confirm that no one is inside the vehicle or within 10 m (33ft) of the vehicle.
Press the SST activation switch and activate the seat belt pretensioner.
Disconnect SST.
Dispose of the front seat outer belt (with the seat belt pretensioner).
| 2. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (When not Installed in Vehicle) |
Remove the front seat outer belt assembly (Click here).
![]() |
Wind the seat belt with the retractor.
When the seat belt is sufficiently wound, cut the seat belt approximately 10 cm (0.328 ft) from the retractor, as shown in the illustration.
![]() |
Check whether SST is functioning.
![]() |
Connect the SST red clip to the positive battery terminal and the black clip to the negative battery terminal.
![]() |
Press the SST activation switch and check that the LED of the SST activation switch illuminates.
![]() |
Connect SST.
Connect SST, then connect the yellow connector to the seat belt pretensioner.
![]() |
Using a service-purpose wire harness for the vehicle, tie the seat belt pretensioner to the tire with a wheel attached.
| Area | Measurement |
| A | 1.25 mm2 or more (0.0019 in2 or more) |
![]() |
Connect SST.
![]() |
Move SST at least 10 m (33 ft) away from the wheel.
Activate the seat belt pretensioner.
Connect the SST red clip to the positive battery terminal and the black clip to the negative battery terminal.
Check that no one is within 10 m (33 ft) of the wheel.
Press the SST activation switch and activate the seat belt pretensioner.
Disconnect SST.
![]() |
Dispose of the front seat outer belt (with the seat belt pretensioner).
Place the front seat outer belt in a plastic bag, tie the end tightly and dispose of it according to local regulations.