Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR (for Hatchback 5 Door)

SIDE AIRBAG SENSOR (for Hatchback 5 Door) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY
  1. Confirm that the ignition switch is turned to off.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    1. Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.



    B106573E01
  1. Insert the hook into the body hole and install the airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 90 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. Do not use a side airbag sensor that has been dropped.
    2. Do not subject the side airbag sensor to any impact or force.

  1. Confirm that there is no looseness by shaking the side airbag sensor.



    B106574E01
  1. Connect the airbag connector.



2. INSTALL CENTER PILLAR LOWER GARNISH RH


    B114297
  1. Engage the 2 clips and the 2 claws and install the center pillar lower garnish.



3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH


B114288
  1. Install the rear door opening trim weatherstrip.



4. INSTALL REAR DOOR SCUFF PLATE RH


    B114287
  1. Engage the 6 claws and install the rear door scuff plate.



5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH


B114286
  1. Install the front door opening weatherstrip.



6. INSTALL FRONT DOOR SCUFF PLATE RH


    B114284
  1. Engage the 8 claws and install the front door scuff plate.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



8. INSPECT SRS WARNING LIGHT
(Click here)