Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR (for Hatchback 3 Door)

SIDE AIRBAG SENSOR (for Hatchback 3 Door) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. INSTALL SIDE AIRBAG SENSOR


B106573E01
  1. Confirm that the ignition switch is turned to off.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    1. Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. Insert the hook into the body hole and install the airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 90 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. Do not use a side airbag sensor that has been dropped.
    2. Do not subject the side airbag sensor to any impact or force.

  1. Confirm that there is no looseness by shaking the side airbag sensor.



    B106574E01
  1. Connect the airbag connector.



2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH


    B114499
  1. Engage the 8 clips, the retainer and the 10 claws and install the front quarter trim panel.



    B114498
  1. Install the belt of the rear seat outer belt onto the rear seat shoulder belt hanger.



3. INSTALL FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY RH (w/ Seat Belt Bar)


    B114759
  1. Install the front seat outer belt bar with the 2 bolts.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }



4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH


    B114286
  1. Install the front door opening weatherstrip.



5. INSTALL FRONT DOOR SCUFF PLATE RH


    B114494
  1. Engage the 8 claws and install the front door scuff plate.



6. INSTALL REAR SEAT ASSEMBLY LH


    B126922E01
  1. Insert the 2 location pins through the 2 body holes and install the rear seat.

  1. Using "TORX" socket wrench E10, install the 4 bolts in the sequence shown in the illustration.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



    B114740E01
  1. Install the rear seat cushion.

  1. Using "TORX" socket wrench E10, install the 3 bolts in the sequence shown in the illustration.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



7. INSTALL REAR SEAT ASSEMBLY RH


    B114684E01
  1. Insert the 2 location pins through the 2 body holes and install the rear seat.

  1. Using "TORX" socket wrench E10, install the 4 bolts in the sequence shown in the illustration.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



    B114660E01
  1. Install the rear seat cushion.

  1. Using "TORX" socket wrench E10, install the 2 bolts in the sequence shown in the illustration.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



8. INSTALL NO. 2 REAR SEAT LEG COVER


    B114739
  1. Engage the 3 claws and install the No. 2 rear seat leg cover.



9. INSTALL NO. 1 REAR SEAT LEG COVER
  1. for RH Side:

    1. Install the No. 1 rear seat leg cover .

  1. for LH Side:

    1. Install the No. 1 rear seat leg cover .



10. INSTALL DECK FLOOR BOX RH (w/o Deck Board)


    B106446
  1. Set the deck floor box and lock the 2 knobs.



11. INSTALL DECK FLOOR BOX LH (w/o Deck Board)

HINT:
Use the same procedure as for the RH side.



12. INSTALL SPARE WHEEL COVER ASSEMBLY (w/ Deck Board)


    B119913
  1. Install the spare wheel cover.



13. INSTALL DECK BOARD SUB-ASSEMBLY (w/o Deck Board)


    B106447
  1. Set the deck board and lock the 2 knobs.



14. INSTALL REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)


    B119912
  1. Install the rear floor carpet.



15. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)


    B114569E01
  1. Engage the 2 claws and install the package tray trim panel.

  1. Install the 5 pieces of hook tape.

  1. Install the 2 package tray trim suspenders.



16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



17. INSPECT SRS WARNING LIGHT
(Click here)