Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Sedan)

ANTI-LOCK BRAKE SYSTEM (for Sedan) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
The intelligent tester can be used in steps 3, 5 and 6.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.DTCS AND FREEZE FRAME DATA CHECK AND CLEARANCE

        NEXT


        4.PROBLEM SYMPTOM CONFIRMATION

          Result
          Proceed to
          Symptom does not occur
          A
          Symptom occurs
          B


        B.
        SYMPTOM SIMULATION
        A


        5.CAN COMMUNICATION SYSTEM CHECK
        1. Check for the output DTC relating to the CAN communication system.

          HINT:
          The ECU of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in the CAN communication system.


          Result
          Proceed to
          CAN communication system DTC not output
          A
          CAN communication system DTC output
          B



        B.
        CAN COMMUNICATION SYSTEM
        A


        6.DTC CHECK

          HINT:
          Click here.


          Result
          Proceed to
          DTC output
          A
          DTC not output
          B


        B.
        PROBLEM SYMPTOM TABLE
        A


        7.DTC CHART

          HINT:
          Click here.


        NEXT


        8.CIRCUIT INSPECTION

          HINT:
          When 2 or more DTCs are detected, perform circuit inspections one by one until the problem is identified.


        NEXT


        9.PROBLEM IDENTIFICATION

          NEXT


          10.REPAIR OR REPLACEMENT

            NEXT


            11.CONFIRMATION TEST

              NEXT

              END