Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

DTC    C1515/15    Torque Sensor Zero Point Adjustment is not Initialized

for Preparation Click here


DESCRIPTION

This DTC does not indicate a malfunction. The power steering ECU outputs this DTC when it determines that the torque sensor zero point calibration has not been performed.

DTC No.
DTC Detection Condition
Trouble Area
C1515/15
Torque sensor zero point calibration not performed.
  1. Torque sensor zero point calibration
  2. Steering column assembly

INSPECTION PROCEDURE

1.PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR)
  1. Perform torque sensor zero point calibration (Click here).


NEXT


2.CONFIRM DTC
  1. Check for DTCs (Click here).

    Result: 
    DTC still output even after performing torque sensor zero point calibration 3 times.
    A
    DTC still output even after performing torque sensor zero point calibration once or twice.
    B
    Normal system code output.
    C

    HINT:
    The steering column assembly must be replaced if C1515/15 is still output even after the torque sensor zero point calibration is performed 3 times.



B
Go to step 1

C
END
A

REPLACE STEERING COLUMN ASSEMBLY