Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

DTC    C1516/16    Torque Sensor Zero Point Adjustment Incomplete

for Preparation Click here


DESCRIPTION

This DTC does not indicate a malfunction. The power steering ECU outputs this DTC when it determines that the torque sensor zero point calibration has not been completed successfully.

DTC No.
DTC Detection Condition
Trouble Area
C1516/16
Torque sensor zero point calibration not completed successfully.
  1. Torque sensor zero point calibration failure
  2. Steering column assembly

INSPECTION PROCEDURE

1.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


2.PERFORM INITIALIZATION (TORQUE SENSOR ZERO POINT)
  1. Perform initialization (Click here).


NEXT


3.PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR)
  1. Perform torque sensor zero point calibration (Click here).


NEXT


4.CONFIRM DTC
  1. Check for DTCs (Click here).

    Result: 
    DTC still output even after performing torque sensor zero point calibration 3 times.
    A
    DTC still output even after performing torque sensor zero point calibration once or twice.
    B
    Normal system code output.
    C

    HINT:
    The steering column assembly must be replaced if C1516/16 is still output even after the torque sensor zero point calibration is performed 3 times.



B
Go to step 1

C
END
A

REPLACE STEERING COLUMN ASSEMBLY