Home › RESTRAINTS › SEAT BELT › OCCUPANT DETECTION SENSOR (for Sedan)

OCCUPANT DETECTION SENSOR (for Sedan) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

NOTICE:
Always use "TORX" socket wrench E10 when installing the front seat.

HINT:
The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.



1. INSTALL FRONT SEAT CUSHION COVER PAD (Built in Occupant Detection Sensor)


    B138627
  1. Install the front seat cushion cover pad with the 2 clips.



    B138331
  1. Engage the 2 claws and the 7 hooks.

  1. Engage the 2 claws and install the connector.



2. INSTALL FRONT SEAT CUSHION INNER SHIELD

HINT:
Use the same procedure as for the driver side .



3. INSTALL FRONT SEAT INNER BELT ASSEMBLY

HINT:
Use the same procedure as for the driver side .



4. INSTALL FRONT SEAT CUSHION OUTER SHIELD

HINT:
Use the same procedure as for the driver side .



5. INSTALL RECLINING ADJUSTER RELEASE HANDLE

HINT:
Use the same procedure as for the driver side .



6. INSTALL FRONT SEAT ASSEMBLY

HINT:
Use the same procedure as for the driver side .



7. INSTALL FRONT SEAT HEADREST ASSEMBLY


    B138314E01
  1. Push in the lock button of the front seat headrest support and install the front seat headrest.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



9. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)