STEERING ANGLE SENSOR (for Hatchback) > INSTALLATION |
| 1. INSTALL STEERING SENSOR |
Engage the 6 claws and insert the 2 pins into the holes to install the steering sensor onto the spiral cable.
| 2. INSTALL SPIRAL CABLE |
Check that the ignition switch is turned to off.
Confirm that the cable is disconnected from the negative battery terminal.
Confirm that the front tires face straight forward.
Confirm that the turn signal switch is in the neutral position.
![]() |
Engage the 3 claws and install the spiral cable.
![]() |
Connect the steering sensor connector.
| *1 | Housing |
Connect the airbag connector.
Connect the horn connector.
| 3. INSTALL STEERING COLUMN COVER |
![]() |
Engage the 2 claws and install the steering column cover (upper).
Engage the 2 claws and install the steering column cover (lower).
Tighten the 3 screws.
| 4. ADJUST SPIRAL CABLE |
![]() |
Center the spiral cable.
Turn the spiral cable counterclockwise until it locks.
![]() |
Turn the spiral cable 2.5 times clockwise from its locked position and align the center marks.
| *1 | Center Mark |
| 5. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks and install the steering wheel assembly onto the steering column assembly.
| *a | Matchmark |
Install the nut.
Connect all connectors to the spiral cable.
| 6. INSTALL STEERING PAD (w/o Steering Pad Switch) |
![]() |
| *1 | Locking Button |
Connect the horn connector.
Connect the airbag connector.
![]() |
Install the steering pad.
Using "TORX" socket wrench T30, tighten the 2 bolts.
| 7. INSTALL STEERING PAD (w/ Steering Pad Switch) |
![]() |
| *1 | Locking Button |
Connect the horn connector.
Connect the airbag connector.
![]() |
Install the steering pad.
Using "TORX" socket wrench T30, tighten the 2 bolts.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. INSPECT SRS WARNING LIGHT |