Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE

REAR BRAKE FLEXIBLE HOSE > INSTALLATION

for Preparation Click here



1. INSTALL REAR FLEXIBLE HOSE
  1. Install the rear flexible hose with 2 new clips.

    NOTICE:
    Install the clip as far as it will go.

  1. Using a union nut wrench 10 mm, connect the 2 brake tubes to the rear flexible hose while holding the rear flexible hose with a wrench.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).



2. BLEED BRAKE LINE
(Click here)


3. BLEED CLUTCH LINE (for Manual Transaxle)
(Click here)


4. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }