Home › Engine / Hybrid System ยท 1NZ-FE › INTAKE / EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE HEATED OXYGEN SENSOR (for Sensor 2)
(Click here)


2. REMOVE FRONT FLOOR CENTER BRACE (w/ Side Mudguard)


A259843
  1. Remove the 2 bolts and the front floor center brace from the body.



3. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    A247550
  1. Remove the 2 bolts and 2 springs, and separate the tail exhaust pipe assembly from the front exhaust pipe assembly.

  1. Remove the 2 exhaust pipe supports and the tail exhaust pipe assembly.

  1. Remove the gasket from the front exhaust pipe assembly.



4. REMOVE NO. 2 EXHAUST PIPE GASKET
  1. Remove the No. 2 exhaust pipe gasket from the front exhaust pipe assembly.



5. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A247548
  1. Remove the 2 bolts and 2 springs, and separate the front exhaust pipe assembly from the exhaust manifold.

  1. Remove the 3 exhaust pipe supports and the front exhaust pipe assembly.

  1. Remove the gasket from the exhaust manifold.



6. INSTALL EXHAUST PIPE GASKET
  1. Remove the exhaust pipe gasket from the exhaust manifold.



7. REMOVE TAIL EXHAUST PIPE BAFFLE SUB-ASSEMBLY (w/ Side Mudguard)


    A171266E01
  1. Using a plastic hammer, uniformly tap out and remove the tail exhaust pipe baffle sub-assembly.
    Text in Illustration 
    *1
    Plastic Hammer